PCB type 4G full band 4G lte full band PCB antenna manufacturer

1 Humidity

The device shall be placed in 90%~95% relative humidity and at 60℃±3℃ for 48h, then place at 25℃±5℃ and less than 65% relative humidity for 2h

It shall fulfill the specification

2 High Temperature

The device shall be placed at 105℃ for 48h, then place at 25℃±5℃ and less than 65% relative humidity for 2h

It shall fulfill the specification

3 Low Temperature

The device shall be placed at ‐40℃ for 48h, then place at 25℃±5℃ and less than 65% relative humidity for 2h

It shall fulfill the specification

4 Temperature Cycle

The device shall be placed at ‐40℃ for 30 min then at 105℃ for 30 min. Cycling shall be repeated 5 times. At the room temperature for 1h

It shall fulfill the specification

5 Salt Spray Test

The device shall be placed in salt spray box (5% NaCl) at 25℃±5℃ for 24h.

It shall fulfill the specification

6 Vibration Test

The device shall be placed to vibration for 2h each in x,y and z axis with the amplitude of 1.5mm, the frequency shall be varied uniformly between the limits of 10Hz~55Hz.

It shall fulfill the

specification

7 Drop Test

The device shall be dropped naturally to cement floor 6 times from the height 1 meter

It shall fulfill the specification

8 Drawing Force Test

The device shall be placed at push/pull tester at the strength of no less than 10N

It shall fulfill the specification

9 Voltage Resistance

1.Insulation spark voltage 1.5KV

2.Sheath spark voltage 1.5KV

3.Insulation resistance to sheath voltage 0.5KV

It shall fulfill the specification

 

Specification
1.Physical Properties
 Connect Type.................. SMA-J
 Operating Temperature......... -40～85°
 Storage Temperature........... -40～95°
2.Electrical Properties
 Frequency Range................... 690~960MHz
1400~2170MHz
2300~2700 MHz
 Impedance..................... 50Ω
VSWR............................ ＜2
 Efficiency........................ 67%
 Peak Gain......................... 4dbI